JD-RCT-115-4085 datasheet
Datasheet for the J&D Rogowski Coil supported by the eGauge. JD-RCT-115-4085 DATASHEET
CT selection guide
Selecting the appropriate CTs for a given installation is a crucial step in obtaining accurate readings. The maximum amperage rating and inner diameter of the CT opening are the two most important elements of CT selection, but there are other
CR5220 DC CT overview
Installation instructions and notes for the CR5220 DC CTs supported by eGauge. Note that these CTs are not bidirectional - the most common installation error with these CTs is incorrect physical orientation. CR5220 DC CT
6″ rope CT installation and accuracy information
The instructions in this document are specifically written regarding the Magnelab 6" CTs carried by eGauge. However, any statements relating to installation and positioning will generally apply to other types of rope CTs (Rogowski coils). Accuracy information is specific to
Connecting unsupported sensors to the eGauge CT ports
The EG30xx and EG4xxx are only certified to be used with current transducers (CTs) as described in the section B.6 of the EG30xx Owner's Manual or section B.6 of the EG4xxx Owner's Manual, respectively. Connecting any other sensors can be dangerous, and will void the eGauge hardware
Extending the length of the CT leads
Split core CTs can be extended with 600V rated twisted pair wire to cover much longer distances. STP (shielded twisted pair) is recommended, as it will reduce noise and interference. If you need to extend a CT wire farther than
Supported CT types
The EG30xx and EG4xxx are Listed Devices, certified to be used with CTs that have the following specifications: UR and CSA, 0.333Vrms output at rated current, and 600V insulation. While any CT with these specifications can be safely attached, only
IMT Si-RS485TC-2T-v-MB irradiance sensor wiring diagrams
The IMT Si-RS485TC-2T-v-MB irradiance sensor requires a serial converter in order to function with the eGauge. eGauge officially supports the Chiyu BF430 (with the eGauge2, EG30xx, or EG4xxx) or eGauge RS485-USB converter (with the EG4xxx only). The IMT sensor using the following color
Multitech Cell Modem Configuration
eGauge offers limited support for the Multitech cellular modem. This hardware is typically used in locations where local Internet access is not available or secured. The Multitech can accept a variety of SIM cards from various providers. However, eGauge only
TP-Link access point setup
eGauge offers limited support for the TP-Link TL-WA701ND when configured for use as a WiFi bridge. This allows the eGauge to connect to the WiFi network at a location where wired Ethernet or PLC options are not practical. Other usage scenarios